Home / SAS Hard Drives / Dell Seagate 300GB 15K SAS 12Gb/s 2.5" HDD جديد 0377CF
الانتقال إلى معلومات المنتج
DELL

Dell Seagate 300GB 15K SAS 12Gb/s 2.5" HDD جديد 0377CF

Refurbished · Tested P/N: HDD-DELL-300G-15K-SAS-0377CF-NEW
السعر الأصلي QAR 220.00
السعر الأصلي سعر التخفيض QAR 220.00
تخفيض نفدت الكمية

Price includes warranty

DELL

In stock · 7 available
اسأل عبر واتساب
مُختبر بالكامل يخضع لاختبار تشغيل قبل الشحن
الضمان مشمول يشمل كل وحدة نبيعها
التوصيل خلال يوم واحد في قطر مجانًا للطلبات فوق 300 ريال
دعم فني متخصص مساعدة في التهيئة عبر واتساب

مواصفات المنتج

العلامة التجارية DELL
رقم المنتج HDD-DELL-300G-15K-SAS-0377CF-NEW
السعة 300 جيجابايت
عامل الشكل 2.5 بوصة SFF
الواجهة 12 جيجابت/ثانية SAS
سرعة الدوران 15 ألف دورة في الدقيقة
Full specification 8 rows
Dell 300GB 15K 12Gb/s SAS 2.5 inch hard drive 0377CF Refurbished · Tested
About this hard drive

Dell 0377CF 300GB 15K RPM 12Gb/s SAS 2.5 inch hard drive, built by Seagate for Dell PowerEdge servers and RAID arrays.

This is a new 300GB 2.5 inch SAS hard drive with a 15,000 RPM spindle, made by Seagate and supplied under Dell part number 0377CF. It fits the small form factor drive bays of Dell PowerEdge servers and connects at 12Gb/s to current Dell PERC controllers and SAS HBAs, negotiating down to 6Gb/s on older backplanes. The 15K spindle gives lower rotational latency than 10K or 7.2K drives. That suits small random reads and writes: database transaction logs, boot and operating system volumes, and RAID sets built around fast spinning disks. Capacity is modest by current standards. Administrators and integrators in Doha and across Qatar buy this drive to rebuild a degraded array with a matching Dell part, or to keep a set of 300GB 15K disks consistent, rather than for bulk storage.

Capacity
300GB
Interface
SAS 12Gb/s
Spindle speed
15,000 RPM
Dell part number
0377CF
SKU HDD-DELL-300G-15K-SAS-0377CF-NEWForm factor 2.5 inch SFF

Specification

Dell part 0377CF is a 12Gb/s SAS drive and is backward compatible with 6Gb/s SAS. On a 6Gb/s link the practical difference is small, because a single 15K spinning disk does not saturate it.

ManufacturerSeagate, for Dell
Dell part number0377CF
Capacity300GB
Drive typeHard disk drive (HDD)
InterfaceSAS
Interface speed12Gb/s
Backward compatibility6Gb/s SAS controllers and backplanes
Form factor2.5 inch (SFF)
Rotational speed15,000 RPM
Controller supportDell PERC controllers and SAS HBAs
SATA-only controllersNot supported
Intended useEnterprise server storage

A SAS drive will not run on a SATA-only controller or an onboard SATA port, even though the connectors look similar. The reverse usually works: SAS controllers can normally run SATA drives. A 15K spindle turns 50 percent faster than a 10K drive, which cuts rotational latency and improves random I/O. Where capacity per bay matters more than seek time, a higher capacity 10K or nearline drive is the better choice.

Installation

Hot-plug bays in Dell PowerEdge servers take the drive in a Dell carrier that matches the server generation; reusing the carrier from the drive being replaced is the usual approach. In a redundant array on a hot-plug backplane, the failed drive can be pulled and this one inserted while the server is running. The PERC controller can then rebuild onto it, either automatically or once it is assigned as a hot spare, depending on controller settings. For a clean rebuild, match capacity, interface and the 15K spindle speed to the drives already in the set, because a virtual disk runs at the pace of its slowest member. Avoid mixing SAS and SATA drives, or 15K and 10K drives, in one virtual disk.

Part numbers and identification

SKUHDD-DELL-300G-15K-SAS-0377CF-NEW
Dell part number (DP/N)0377CF

Condition & testing

  • Tested in a compatible system
  • Verified against the listed part number and specification
  • Fully working; minor cosmetic marks are possible on refurbished units.
  • 6-month warranty on every unit we sell, with installation and support across Qatar.

Why buy refurbished

Enterprise hardware, tested in Doha, at a fraction of the price of new

Every unit we sell has already proven itself in a data centre. We test it again, grade it, and back it with a warranty before it leaves our stock.

Talk to our team

Tested before it ships

POST, burn-in, memory and power-supply checks on every unit. Anything that fails is repaired or pulled from stock, not sold.

Same performance, lower cost

A Xeon runs the same workloads whether it is new or two years old. Spend the difference on more CPUs, memory or storage.

In stock, not on order

New enterprise hardware can take weeks or months to arrive. Ours is on the shelf in Doha and delivered across Qatar within a day.

Warranty and local support

Every unit is covered. Installation, configuration and hardware support are handled by our own team in Qatar, not a call centre abroad.