قطع الغيار والملحقات

No. Dell and HPE have both changed caddy designs between server generations, and a caddy from one generation may not latch or make proper contact in another. Size matters too: 2.5-inch and 3.5-inch bays use different caddies, although adapters let a 2.5-inch drive sit in a 3.5-inch bay. Send the server model and the team will confirm the right caddy.

It is best not to. Most servers expect both supplies in a redundant pair to be the same model and wattage, and a mismatch can raise a fault, disable redundancy or cap the power available. When replacing a failed supply, match the one still installed. When upgrading to a higher wattage, replace both supplies together.

They are two different HPE hot-plug power supply designs, with different shapes and connectors, used in different ProLiant generations. They are not interchangeable, so a Flex Slot supply will not fit a Common Slot bay or the reverse. Check the label on the existing supply, or send the server model, and the team will confirm the right one.

Usually, yes. A replacement board normally needs the server's service tag or serial number restored, and the BIOS and management controller updated and configured. Licences tied to the board, such as remote management licences, may also need attention. ServerDove can fit the board and carry out this base configuration as a service.

Often, yes. The listed range is what is on the shelf in Doha, and the team can quote for other Dell and HPE parts. The quickest route is the part number from the label of the existing part, or the server model with a photo. Send it by WhatsApp on +974 5521 2108 or by email to sales@serverdove.com.

Yes. Installation, racking, cabling and base configuration are available as a service. That covers jobs such as fitting rail kits and racking servers, replacing power supplies and fans, and fitting boards or backplanes that also need firmware or configuration work afterwards. Ask for the service when you request your quote.